MAXTIDE MACHINERY CO., LTD.

What are the categories of Dongguan manufacturers Teflon Y-rings?

Y-type seals can be divided into wide Y-rings, narrow Y-rings and Yx-type seals according to the length and width of the section. The pressure resistance of the wide-section Y-ring is slightly smaller than that of the narrow Y-ring, which can only be applied to the working environment of P<20MPa, and the narrow Y-ring can be used for the working pressure P<32MPa. According to whether the height of the two lips is the same, the Y-type sealing ring can be divided into the unequal lip Y-ring seal for the shaft, the unequal lip Y-ring seal for the hole and the common lip lip Y-type seal for the shaft hole. ring. Y-rings are manufactured in different materials, and can be divided into nitrile rubber Y-rings, fluoroelastomer Y-rings, and urethane-rubber Y-rings. Working speed range: 0.01 to 0.6 m/s when made of butyl rubber; 0.005 to 0.3 m/s when made of fluororubber; 0.01 to lm/s when made of urethane rubber. The sealing performance, service life of the Y-ring and the working pressure limit of different retaining rings are preferably made of urethane rubber.

The Y-ring has a Y-shaped cross section and is a typical lip seal. Widely used in reciprocating dynamic sealing devices, its service life is higher than O-rings. The applicable working pressure of the Y-ring is not more than 40MPa, and the working temperature is -30~80°C. Dongguan Teflon Y-type seal ring manufacturers analyze its characteristics: reliable sealing performance; small friction resistance, smooth movement; good pressure resistance, wide pressure range; simple structure, low price; easy to install. It can be distinguished from the inclination angle of the lip of the largest and smallest diameter sides of the Y-ring, that is, the inclination angle of the inner lip and the outer lip: if the inclination angle of the lip of the largest diameter side is smaller than the angle of the smallest diameter side, the side is For the shaft; the opposite is for the hole. Because the Y-ring seals against the compression and stretching of the slanted lip. The shaft is stretched by the inner lip.


Tech Center
The copyright of the article belongs to the original author. In case of the copyright infringement, please contact us and we should deal with it in time.